Klark Teknik DN100 Direct Injection Box with Balanced I/O
The new Klark Teknik DN100 Direct Injection Box features a ground-up redesign to provide an extended dynamic range, lower noise floor and all the world-class audio performance you'd expect from Klark Teknik. DN100 is also designed to handle the rigours of life on the road: a thick aluminium shell protects the electronics, and this in turn is protected by a tough silicone rubber casing, which is replaceable and available as a spare part.There's also a security slot to to secure the DN100 using Kensington MicroSaver security cable.
Input
Type active electronic, balanced or unbalanced
Impedance 1M O nominal, balanced or unbalanced (jack connectors) 20K Ohms (XLR input only)
Connectors 2 quarter inch jacks and 3-pin XLR linked in parallel
Maxmum level 30dBu
Attenuator 30dB switchable
Output
Type Transformer Isolated, balanced
Impedance 300 Ohms
Connector 3 pin XLR
Max. Level 10dBu with load >2k Ohms
Min. load 600 Ohms
Performance
Noise -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
Frequency response +0.5/-1dB 20Hz to 20kHz
Distortion (THD+N) output <0.01% @ 1kHz, +4dBu
Power Requirement
Voltage +48V Phantom *
Current consumption <10mA
Dimensions
Length 142mm (5.6 inch)
Width 106mm (4.2 inch)
Height 60mm (2.35 inch)
Weight <1kg
* The DN100 has been designed to allow use at phantom voltages less than +48V. The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V Phantom power.
Input
Type active electronic, balanced or unbalanced
Impedance 1M O nominal, balanced or unbalanced (jack connectors) 20K Ohms (XLR input only)
Connectors 2 quarter inch jacks and 3-pin XLR linked in parallel
Maxmum level 30dBu
Attenuator 30dB switchable
Output
Type Transformer Isolated, balanced
Impedance 300 Ohms
Connector 3 pin XLR
Max. Level 10dBu with load >2k Ohms
Min. load 600 Ohms
Performance
Noise -100dBu, 20Hz to 20kHz unweighted, with input terminated by 10k resistor
Frequency response +0.5/-1dB 20Hz to 20kHz
Distortion (THD+N) output <0.01% @ 1kHz, +4dBu
Power Requirement
Voltage +48V Phantom *
Current consumption <10mA
Dimensions
Length 142mm (5.6 inch)
Width 106mm (4.2 inch)
Height 60mm (2.35 inch)
Weight <1kg
* The DN100 has been designed to allow use at phantom voltages less than +48V. The unit will function down to +20V (when used with 6k8 dropping resistors) but with reduced headroom and dynamic range. All the specifications above are quoted using standard +48V Phantom power.
