Muxlab 500758 4K Over IP Extender Kit With PoE

$998.00
Unit price per

The HDMI 4K over IP PoE Extender Kit allows HDMI equipment to be extended up to 330ft (100m) up to 4K (3840?160) resolution @ 30Hz via one (1) Cat5e/6 cable in a point-to-point configuration. Point-to-multipoint and multipoint-to-multipoint configurations are also possible by connecting several units to the same local Ethernet network, and the device supports PoE (PD) if used with a PoE (PSE) Ethernet Switch.

Features:

Supports HDMI up to 4K @ 30Hz (4:4:4)
Supports 100?s of Transmitters & Receivers depending on network bandwidth
Extend HDMI up to 330ft (100m) over Cat5e/6
Supports point-to-point, point-to-multipoint and multipoint-to-multipoint applications
Supports audio insert (TX) & audio extract (RX)
Supports RS232 and IR transmission for remote control

Specifications:

Environment: HDMI 1.4
Devices: Blu-Ray, projectors, monitors, TV, PC, laptops, servers supporting HDMI.
Bandwidth: 300MHz
Signals: HDMI 1.4 protocol
Connectors:
One (1) HDMI receptacle.
One (1) RJ45S for Cat 5e/6 unshielded or shielded twisted pair.
Two (2) 3.5mm jacks for IR emitter (on TX)/sensor (on RX).
Two (2) 3.5mm jacks for audio insert (on TX)/audio extract (on RX).
One (1) DB9 for the RS232
Four (4) DIP Switches for device ID addressing.
Maximum Distance Based on a maximum length of 6.6ft (2m) of HDMI cable per end: Cat5e/6: 330ft (100m) up to 4K @ 30Hz. Note: When installed in an electrically noisy environment, an STP cable must be used. Also, crossconnection reduces the effective distance depending on the grade of twisted cable used.
Latency: Typical one (1) Frame (16ms), maximum 2 frames (33ms)
Compression: Proprietary Compression
Bandwidth: Up to 850Mbps
Network Requirement: 1000BaseT with Jumbo Frame
IR Frequency: 38 to 56KHz
RJ45 Pin Configuration: Reverse Polarity Sensitive. Use EIA/TIA 568A or 586B straight-through wiring.
RJ45 Link: Pin 1 (R) Pin 2 (T); Pin 3 (R) Pin 6 (T); Pin 4 (R) Pin 5 (T); Pin 7 (R) Pin 8 (T)
Cable: One (1) Cat 5e/6 or better twisted pair cables required
Power Source: This device supports PoE (PD), an external power supply is not included. It is intended to be powered via a PoE (PSE) Ethernet Switch. If required, an optional power supply (500993) may be purchased separately.
PoE: IEEE 802.3af
Power Consumption Transmitter: 2.85Watt Receiver: 2.55Watt
Temperature Operating: 0° to 40°C Storage: -20° to 85°C
Humidity: Up to 95% non-condensing
Dimensions: 4.40? x 5.08? x 1.00? (112mm x 129mm x 25mm)
Weight 1.5lbs (0.68kg)
Compliance Regulatory: FCC, CE, RoHS Flammability: 94V0
Warranty: 2 years

Warranty:

2 Years Part & Labor